PLEASE READ THIS ENTIRE PAGE BEFORE EMAILING ME.

PLEASE!  PLEASE!  PLEASE!
Do NOT add me to your bulk email list for jokes,
silly videos, and the like.  

To send an email to
 
  you can . .

If you have Javascript enabled you will see a "click here" above after the words "you can" that you can click on to launch your mail program. If you don't have Javascript enabled you can manually send a message to the address above.

When emailing me please insure that your imbedded "return address" in your E-mail program is correct. (You might want to put your address in the body of your message if you are not sure.)   I have had messages from people whose imbedded email return address was invalid (hence the notice below) and they probably think I'm ignoring them.  If you don't get a reply from me within 3 - 5 business days, check to make sure that your email program is properly identifying you. (I really do answer all email.  But only if I receive it.)  

If you have emailed me and have not received a reply within 3-5 working days,  click here   to see if your name is on this list.  If it is, please  resend your message and insure that your verified correct email address is included in the body of your message.  If it is not on this list then I probably either never received your email or your ISP is blocking me.  Because of all the spam problems on  the Internet some ISPs (like AOL  and Hotmail) may be blocking my replies.  Be sure that your mail program is set to receive messages from Commspeed.net.

Also please make sure that your in-box isn't full.  A surprising number of my replies bounce with "mailbox full" errors.

Please put your actual topic in the subject line as I filter out any mail with a blank subject line or "Hi there," and similar headers as "spam."

A NOTE ABOUT BALLISTIC INQUIRIES

I frequently get requests for a ballistics runs for a particular load.   I will be glad to do a single run for you but please note that you must supply the following data.

• Bullet brand, weight, and type or name

• Muzzle velocity.  (Unless you know this I can only guess from loading data and they can be off by quite a lot from the real world)

• Distance from center of bore to the center of your scope tube

• The distance you want for a zero. (If not supplied I will send data for the optimum zero for your load)

If you want additional runs there will be a modest fee for such work.

Use your browser's "BACK" button to return to where you came from.

Updated 2010-07-26